Custom Router Table

I just finished building my router table insert for combined workbench. The process was fairly simple. I used a jigsaw to cut the insert hole, and then used a router to create an inset pocket on the top to hold the Bench Dog router plate. To make sure that it was flush, I used the plate to set the depth of the router bit before cutting it out. The fence is still on the way, and I will need to create a pocket for the router bit. I decided to go with extruded aluminum from [8020.net](https://8020.net/shop/2040-s.html#). I will stack two of them and bore a hole through them so that I can mount that to the table surface and pivot on the right side. This will allow me to secure it from the other side, then open and close the fence as needed for cuts.

Leave a Reply

Your email address will not be published. Required fields are marked *